Peek-Ins allow users to take on demand snapshots from the Qolsys IQ Panel 2 panel camera using the Alarm.com website or app.

Captured images are saved in the Images event gallery.  

Requirements 

• The Qolsys IQ Panel 2 must be connected to Wi-Fi.
• The Qolsys IQ Panel 2 must be on firmware version 2.3.0 +.

Note: If you do not see the following options, contact your service provider. 

To request a Peek-In using the website:  

1. Log into the website.
2. Click  on the Images card.
3. Click either or next to the panel camera.
4. The image is uploaded to the Images Event Gallery. When the image is available for viewing, a notification is sent to all Peek-In notification recipients. 

To request a Peek-In using the app: 

1. Log into the app.
2. Tap .
3. Tap Images.
4. Tap  .
   • Tap Peek-In, press the image sensor you would like to capture the image.
   • Tap Next Motion to have the image sensor upload an image the next time the image sensor detects motion.
   • Tap Now To have the image sensor upload an image immediately.

To configure Peek-In recipients:  

1. Log into the website. This can only be configured on the website. 
2. Click Automation.
3. Click  for Peek-Ins & Manual Image Uploads.
4. To choose notification recipients, click + Add Recipient.
5. Click to select the desired recipients from the Address book, to add an unlisted recipient click + New. When recipients has been selected, a checkmark appears next to their contact information.

   Note: When a Peek-In is requested, an image of the capture is attached to the email or SMS message.
    

6. Click Close.
7. Verify the rule is configured with the correct settings.
8. Click Save.